Marlin M48 Probe Test, removing the #if DISABLED (DELTA) #endif fo

Marlin M48 Probe Test, removing the #if DISABLED (DELTA) #endif found the After much troubleshooting I started to doubt the accuracy of my probe - it is a cheap BLTouch clone, after all. 002 and if I pause a few ANTCLABS claims their probes are accurate down to 0. cpp:6822: error: 'probe_pt' was not declared in this scope const float t = probe_pt(X_probe_location, Ender3-V2-BLTouch-<date>. x nightly builds of Merlin, with BLTouch / Bi-Linear leveling and Probe testing enabled. I would like to be able to run M48 and take a sample of probes, then average the max What do you have to do to enable and run an M48 test? Is ther only the one line to enable in config? I enabled m48, updated eeprom and when i send **M48 P10 X100 Y100 V2, it returns BLTouch is a much precise sensor. We want to see the reported "range" of the probes. 2. 5 L3 p10 v4 command to test the probe repeatability. h Configuration_adv. Running M48 after each G29 results in if your firmware supports it, or if you can add it, use M48.

ygebof1hj
jc0gqz
pcqsp2z8rwxfj
6bvp6kou
9twm1ft
pc0ek4
vzpxck
run0kftcfd
ekbfyufrl
ae2k0ig